Zonescore.

We're still verifying Arlington County, VA's answers against the county code.

Arlington zoning › R2-7

R2-7Two-Family and Townhouse Dwelling District

Arlington County, VA · Arlington County Zoning Ordinance (ACZO)

R2-7 (ACZO §5.9) permits one-family, two-family (semidetached and duplex), and townhouse dwellings by-right. One-family lots require 5,000 square feet; two-family and townhouse dwellings require 3,500 square feet of lot area per unit (7,000 sq ft site for a duplex, 10,500 sq ft for a townhouse project). Height is limited to 35 feet. The district provides moderate-density housing choice within established residential areas.

Development standards in R2-7

Maximum height35 ft5.9
Rear setback25 ft3.2.6
Front setbackFor any structure other than a one- or two-family dwelling (such as a townhouse), the larger of 50 ft from the street centerline or 25 ft from the street right-of-way line; for a one- or two-family dwelling or an expanded housing option development, 25 ft from the street right-of-way line, which may be reduced to the average of the existing front walls on that frontage but not below 15 ft (18 ft for a parking garage) — see 3.2.6
Side setbackFor a one-family house or an expanded housing option development: 10 ft each side, but one side may be reduced to 8 ft, and both sides together must be at least 30 percent of the lot's required width; for other buildings, see §3.2.6.A.2(d) and (e) — see 3.2.6
Front setback and Side setback are banded in the ordinance — it depends on what you build or on the lot itself, so no single figure is true for the whole zone. The cited table is the authority; read the tier that matches your intended structure.
Read from Arlington County Zoning Ordinance (ACZO), effective through 2026-06-13. We last checked with the publisher on 2026-09-14 and found nothing newer -- a check on that date, not a promise about today.
How complete is this market? Across 38,683 parcels we answer 65.5% of the 6 questions this site is built to answer, each with a source you can check. The rest are shown as “not recorded” rather than filled in — we would rather be short than wrong.

Permitted uses in R2-7

"Conditional" means the use generally requires a public hearing or special-exception approval — a very different timeline and risk profile from a by-right permit.

This is the zone. What about the parcel?

Zone rules are the starting point — the answer for a specific property also depends on lot size, overlays, existing improvements and site conditions. Run a free address lookup to see what applies to one property.

Look up an address

Sources

Values are read from the Arlington County Zoning Ordinance (ACZO). Where a district allows more density through site plan approval than by right, both are shown -- they are very different entitlement paths.

Other Arlington zones

C-1 C-1-O C-1-R C-2 C-3 C-O C-O-1.0 C-O-1.5 C-O-2.5 C-O-A C-O-CC C-O-ROSS C-R M-1 M-2 MU-VS R-10 R-10T R-20 R-5 R-6 R-8 R15-30T RA14-26 RA4.8 RA6-15 RA7-16 RA8-18 S-3A S-D